Chassis
Steering Gearbox Removal and Installation
In this manual: Chassis
~1min read
1special tools
Special Tools Required
- Ball Joint Thread Protector, 12 mm 07AAF-SDAA100
- Ball Joint Remover, 28 mm 07MAC-SL0A202
- Subframe Adapter VSB02C000016
*Available through the Honda Tool and Equipment Program, 888-424-6857.
Note these items during removal:
Using clean solvent and a brush, wash any oil and dirt off the valve body unit, it's lines, and the end of the steering gearbox. Blow dry with compressed air.
Lower the front subframe from the body, and remove the steering gearbox through the gap produced by lowering the front subframe.
Was this page helpful?