Chassis

Installation

8steps
~48min
2/5difficulty
010203040509.37N·mlb·ft
Tightening torque found on this page
Done 0 of 8
  1. Install the VSA modulator-control unit (A) onto the bracket (B).

  2. AB6 x 1.0 mm9,3 N·m (0.95 kgf·m, 6.9 lbf·ft)6 x 1.0 mm9,3 N·m (0.95 kgf·m, 6.9 lbf·ft)

  1. Install the VSA modulator-control unit (A) with the bracket (B) to the body, then install the VSA modulator-control unit bracket mounting bolts (C).

  2. Align the connecting surface of the VSA modulator-control unit 32P connector (A) to the VSA modulator-control unit.

  3. Pull down the lever (B) of the VSA modulator-control unit 32P connector, then confirm the connector is fully seated.


  1. Connect the 10 mm brake lines and the 12 mm brake lines to the VSA modulator-control unit (A).

    NOTE: The brake lines are connected to the master cylinder (B), the left-rear (C), the right-front (D), the left-front (E), and the right-rear (F) brake systems.

  2. Install the air cleaner.

  3. Bleed the brake system.

  4. Do the VSA modulator-control unit update.

  5. Do the VSA sensor neutral position memorization procedure.