Accessories Keyless Security System In this manual: Accessories Vehicle General — 4Accessories — 103Body — 232Chassis — 83Electrical — 28HVAC — 26 ~1min read How the One Touch Starting System Circuit Works (Factory without Keyless Access) One Touch Starting Power ControlHow the Circuit WorksThe One Touch Starting system sends the ignitionswitch start input to the PCM. When the PCM seesthis signal, it engages two cut relays to energizethe starter motor.The PCM keeps the starter motor engaged until:1) The engine starts.or2) The starter has run for a several seconds,but the engine did not start.(actual crank time varies with temperature).To provide redundancy, the starter circuitincludes two cut relays between the PCM andstarter. Both relays must close before the starterengages.Once engaged, the starter remains on evenif the ignition switch returns to position II (ON).To reduce overall electrical load, the IG2(Hot in ON) and accessory (ACC) power circuitsboth include a circuit cut relay. These relays arenormally closed, but open while the starter isengaged. If either cut relay fails, the engine startsbut some vehicle electrical systems oraccessories will not receive power.2012 American Honda Motor Co., Inc. In this section Keyless Access LF Antenna (Front Interior) ReplacementKeyless Access LF Antenna (Rear Bumper) ReplacementKeyless Access LF Antenna (Rear Interior) ReplacementKeyless Access System DescriptionKeyless Access Control UnitPower Mode Control FunctionMulti-Information Display Indication PatternImmobilizer Function, Keyless Buzzer ReplacementRear License Trim Replacement (With Keyless Access)Sliding Door Outer Handle Replacement (With Keyless Access)Steering Lock Replacement (With Keyless Access)Under-Dash Subrelay Box Test/Replacement (With Keyless Access) ← Previous Immobilizer Next → Keyless Access LF Antenna (Front Interior) Replacement Was this page helpful?👍 Yes👎 No