Rearview camera image does not change when selecting different views
NOTE:
Check the vehicle battery condition first.
You can select three different rearview camera angles for backing up. If there is no camera image on the display, go to Rearview camera image does not come on or work properly troubleshooting.
Check any official Honda service website for more service information about the navigation system.
Check the connectors for poor connections or loose terminals.
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
Move the shift lever to R.
Press the interface dial to see if the rearview image changes between the wide view, the normal view, and the top down view in this order.
Move the shift lever to P or N.
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
Disconnect audio-navigation unit connector G (24P).
Disconnect the rearview camera 12P connector.
Check for continuity between body ground and audio-navigation unit connector G (24P) terminals No. 5 and No. 18 individually.
Check for continuity between audio-navigation unit connector G (24P) terminals No. 5 and No. 18.
Check for continuity between audio-navigation unit connector G (24P) terminals No. 5 and No. 18 and rearview camera 12P connector terminals No. 7 and No. 8 respectively.
Substitute a known-good rearview camera.
Reconnect all the connectors, and recheck.