Hyundai Elantra AD Quiz
Body Electrical System

Blind-Spot Detection Unit Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
6steps
~36min
2/5difficulty
Done 0 of 6

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear bumper. (Refer to Body - "Rear Bumper")
  3. Loosen the mounting nuts, then remove the BSD unit (A).
    • Be careful not to separate the bracket from the rear bumper when removing the BSD sensor.

Installation

  1. Install the BSD units to the rear bumper.
  2. Install the rear bumper.
  3. Connect the negative (-) battery terminal.
    • When installing, make sure not to confuse the left (master) and right (slave) units.
    • Connect the BSD unit connectors to the wiring harness connectors.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.