Hyundai Elantra AD Quiz
Drive Shaft and Axle

Dynamic Damper Repair Procedures

In this manual: Drive Shaft and Axle
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
13steps
~83min
4/5difficulty
1special tools
Done 0 of 13

Removal

  1. Remove the front drive shaft. (Refer to Drive Shaft Assembly - "Front Drive Shaft")
  2. Remove the TJ joint assembly. (Refer to Drive Shaft Assembly - "TJ Joint")
  3. Remove both dynamic damper bands (B) from the dynamic damper (A).
  4. Secure the drive shaft (A) in a vise (B), as shown in the illustration.
  5. Apply soap powder to the shaft to prevent damage between the shaft splines and the dynamic damper when the dynamic damper is removed.
  6. Carefully separate the dynamic damper (A) from the shaft (B).

Installation

  1. Apply soap powder to the shaft to prevent damage between the shaft splines and the dynamic damper.
  2. Install the dynamic damper.
  3. Install the dynamic damper bands.
  4. Using SST (09495-39100), secure the TJ boot clamps.
    • Do not reuse the boot band.
  5. Install the TJ joint assembly. (Refer to Drive Shaft Assembly - "TJ Joint")
  6. Install the front propeller shaft. (Refer to Drive Shaft Assembly - "Front Drive Shaft")
  7. Check the front alignment. (Refer to Suspension System - "Front Wheel Alignment")

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.