Hyundai Elantra AD Quiz
Body (Interior and Exterior)

Floor Console Assembly Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
22steps
~132min
4/5difficulty
Done 0 of 22

Replacement

[M/T]
  • Wear gloves to avoid cutting your hands.
  • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  • Use a plastic panel removal tool to remove the interior trim parts without damaging the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the shift lever knob and boot (A) by pulling them upward.
  2. Remove the rubber mat (A).
  3. Using a screwdriver or remover, remove the parking brake cover (A).
  4. Using a screwdriver or remover, remove the console upper cover (A).
  5. Disconnect the connector (A).
  6. Using a screwdriver or remover, remove the console garnish (A).
  7. Remove the storage box garnish (A).
  8. Loosen the mounting screws and bolts, then remove the rear console assembly (A).
  9. Disconnect the connectors (A).
  10. Loosen the mounting screws and remove the front console assembly (A).
  11. To install, reverse the removal procedure.
    • Make sure the connector is properly connected.
    • Replace any damaged clips (or pin-type retainers).

[A/T]
  • Wear gloves to avoid cutting your hands.
  • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  • Use a plastic panel removal tool to remove the interior trim parts without damaging the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. To remove the shift lever knob and boot (A), pull them upward.
  2. Remove the rubber mat (A).
  3. Using a screwdriver or remover, remove the floor console upper cover (A).
  4. Disconnect the connectors (A) from the floor console upper cover.
  5. Using a screwdriver or remover, remove the console garnish (A).
  6. Using a screwdriver or remover, remove the parking brake cover (A).
  7. Remove the storage box garnish (A).
  8. Loosen the mounting screws and bolts, then remove the floor console assembly (A).
  9. Disconnect the connectors (A).
  10. Loosen the mounting screws and remove the front console assembly (A).
  11. To install, reverse the removal procedure.
    • Make sure the connector is properly connected.
    • Replace any damaged clips (or pin-type retainers).

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.