Hyundai Elantra AD Quiz
Body (Interior and Exterior)

Rear Console Cover Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
4steps
~24min
2/5difficulty
Done 0 of 4

Replacement
  • Wear gloves to avoid cutting your hands.
  • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  • Use a plastic panel removal tool to remove the interior trim parts without damaging the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the floor console assembly. (Refer to Floor Console - "Floor Console Assembly")
  2. Loosen the rear console mounting screws.
  3. Using a screwdriver or remover, remove the rear console cover (A).
  4. To install, reverse the removal procedure.
    • Make sure the connector is properly connected.
    • Replace any damaged clips (or pin-type retainers).

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.