Front Seat Belt Pretensioner Repair Procedures

Replacement

When installing the seat belt, take care not to damage the pretensioner.

1. 1
   Remove the center pillar upper garnish. (Refer to Body Trim - "Center Pillar Garnish")
2. 2
   Loosen the upper front seat belt anchor mounting bolt, and remove the upper front seat belt anchor (A).

   Tightening torque: 39.2 ~ 54 N·m

   

3. 3
   Disconnect the connector (A).

   

4. 4
   Loosen the mounting bolt and remove the front seat belt pretensioner (A).

   Tightening torque: 39.2 ~ 54 N·m

   

5. 5
   To install, reverse the removal procedure.

   After installing the front seat belt pretensioner, make sure the airbag indicator illuminates for approximately 6 seconds when the ignition is turned on, and then goes off. Make sure the connector is properly connected. Replace any damaged clips (or pin-type retainers).