Rear Hub - Carrier Repair Procedures

Removal

[Disc Type]

1. 1
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the rear wheel and tire (A) from the front hub.

   Tightening Torque: 107.9 ~ 128 N·m

   

   Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

3. 3
   Remove the parking brake cable fixed clip (A).

   

4. 4
   Remove the rear brake caliper. (Refer to Brake System - "Rear Disc Brake")
5. 5
   Loosen the screws and remove the brake disc.

   Tightening Torque: 4.9 ~ 5.9 N·m

   

6. 6
   Disconnect the rear wheel speed sensor connector (A).

   

7. 7
   Loosen the bolts and remove the hub bearing (A).

   Tightening Torque: 49.0 ~ 59 N·m

   

   

8. 8
   To install, reverse the removal procedure.

[Drum Type]

1. 1
   Remove the rear wheel and tire (A).

   Tightening torque: 88.3 ~ 108 N·m

   

2. 2
   Disconnect the parking brake clip (A).

   

3. 3
   Loosen the bolt and remove the parking brake cable (A).

   Tightening torque: 18.6 ~ 26 N·m

   

4. 4
   Loosen the screw (A) and remove the disc (B).

   Tightening Torque: 4.9 ~ 5.8 N·m

   

5. 5
   Remove the springs (A, B, C).

   

   

   

6. 6
   Remove the boot (A).

   

7. 7
   Disconnect the parking brake cable (A) from the lever (B).

   

8. 8
   Remove the brake hose (A) and loosen the cylinder bolt.

   

9. 9
   Loosen the hub retaining bolt and remove the hub (A) from the torsion beam.

   Tightening Torque: 49.0 ~ 59 N·m

   

   

10. 10
    To install, reverse the removal procedure.

Inspection

1. 1
   Check the hub for cracks and worn splines.
2. 2
   Check the brake disc for scratches and damage.
3. 3
   Check the rear axle beam for cracks.
4. 4
   Check the bearing for cracks or damage.