Wheel Repair Procedures

Hub Nut Tightening Sequence

1. 1
   Tighten the hub nuts as follows.

   Tightening Torque: 107.9 ~ 128 N·m

   

   When using an impact wrench, the final tightening torque must be checked with a torque wrench.

2. 2
   Raise the vehicle.
3. 3
   Measure wheel runout with a dial indicator as shown in the illustration below.

   Run out	Aluminum
   Radial mm (in)	Below 0.3 (0.0118)
   Lateral mm (in)	Below 0.3 (0.0118)

4. 4
   If the measured value exceeds the specified value, replace the wheel.