Hyundai Genesis DH Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
10steps
~60min
3/5difficulty
Done 0 of 10

Inspection

Check this by performing the procedure below to confirm that the ECM operates normally.
  1. Turn the ignition switch to the "ON" position.
  2. Cover the front sensor.
  3. Direct light onto the rear-facing sensor.
  4. The ECM dims as soon as the rear-facing sensor detects a specified brightness level.
    If this test is performed during the daytime, the ECM may darken as soon as the front sensor is covered.
  5. When the reverse gear is engaged, the ECM does not dim. When light is directed at both the front-facing and rear-facing sensors, the ECM must not dim.

Removal

  1. Remove the mirror wiring cover (A) and the rain sensor cover (B).
  2. Disconnect the mirror connector (A).
  3. Remove the mirror (A) by pulling it upward in the direction indicated by the arrow below.
    Do not damage the mounting bracket when removing the mirror.

Installation

  1. When installing the mirror, be careful not to damage the mounting bracket.
  2. Install the mirror wiring cover and the rain sensor cover after reconnecting the connector and tightening the screw.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.