Hyundai i20 Quiz
Body Work (Interior and Exterior)

Floor Console Assembly Repair Procedures

In this manual: Body Work (Interior and Exterior)
General Information — 17Engine Mechanical System — 79Engine Electrical System — 50Emission Control System — 22Engine/Fuel Control System — 107Clutch System — 27MANUAL TRANSMISSION SYSTEM — 21Drive Shaft and Axle — 18Suspension System — 29Steering System — 21Restraint — 41Braking System — 53Body Work (Interior and Exterior) — 190Body Electrical System — 181Heating, Ventilation and Air Conditioning — 58
17steps
~102min
4/5difficulty
Done 0 of 17

REPLACEMENT

[M/T]

  1. Remove the shift lever knob (A) by turning it counterclockwise.
  2. Using a screwdriver or remover, remove the front console upper cover (A).
  3. Place a flat-tip screwdriver in the middle of the gap and carefully pry up the floor console front panel (A).
  4. Disconnect the connectors (A).
  5. Using a screwdriver or remover, remove the parking brake cover (A).
  6. Remove the rear console tray trim (A).
  7. Loosen the retaining clips, screws and bolt, then remove the floor console (A).
  8. To install, perform the removal procedure in reverse order.

[A/T]

  1. Remove the shift lever knob and boots (A) by pulling them.
  2. Using a screwdriver or remover, remove the front console upper cover (A).
  3. Disconnect the connectors (A).
  4. Place a flat-tip screwdriver in the middle of the gap and carefully pry up the floor console front panel (A).
  5. Disconnect the connectors (A).
  6. Using a screwdriver or remover, remove the parking brake cover (A).
  7. Remove the rear console tray trim (A).
  8. Loosen the retaining clips, screws and bolt, then remove the floor console (A).
  9. To install, perform the removal procedure in reverse order.

Test yourself

A quick Hyundai i20 quiz: every answer comes with an explanation and a link to the manual page.