Hyundai i20 Quiz
Engine Mechanical System

Engine Mount Repair Procedures

In this manual: Engine Mechanical System
General Information — 17Engine Mechanical System — 79Engine Electrical System — 50Emission Control System — 22Engine/Fuel Control System — 107Clutch System — 27MANUAL TRANSMISSION SYSTEM — 21Drive Shaft and Axle — 18Suspension System — 29Steering System — 21Restraint — 41Braking System — 53Body Work (Interior and Exterior) — 190Body Electrical System — 181Heating, Ventilation and Air Conditioning — 58
20steps
~120min
4/5difficulty
04080120160200107.880N·mlb·ft
Tightening torque found on this page
Done 0 of 20

Removal and Installation

Engine mounting bracket
  1. Remove the engine undercover. (Refer to Engine and Transaxle Assembly - "Engine Undercover")
  2. Place a jack on the edge of the oil pan to support the engine.
  3. Remove the engine mounting bracket (A). Tightening torque: Nut (B): 88.2 - 108 N·m Bolt (C) and nut (D): 58.8 - 74 N·m
  4. Remove the reservoir tank. (Refer to Cooling System - "Reservoir Tank")
  5. Remove the engine mounting bracket (A).

    Tightening torque: 44.0 - 64 N·m

  6. To install, perform the removal procedure in reverse order.
  7. Remove the engine undercover. (Refer to Engine and Transaxle Assembly - "Engine Undercover")
  8. Remove the roller rod bracket (A). Tightening torque: Bolt (B): 107.9 - 128 N·m Bolt (C): 49.0 - 64 N·m
  9. Remove the roller rod mounting bracket (A).

    Tightening torque: 49.0 ~ 69 N·m

  10. To install, perform the removal procedure in reverse order.
  11. Remove the air duct and air cleaner assembly. (Refer to Intake and Exhaust System - "Air Cleaner")
  12. Remove the battery. (Refer to Engine Electrical System - "Battery".)
  13. Remove the Engine Control Module (ECM). (Refer to Fuel System/Engine Control - "Engine Control Module (ECM)")
  14. Remove the battery tray. (Refer to Engine Electrical System - "Battery")
  15. Remove the engine undercover. (Refer to Engine and Transaxle Assembly - "Engine Undercover")
  16. Place a jack on the edge of the transaxle to support it.
  17. Remove the cover (A).
  18. Remove the transaxle bracket mounting bolts (A).

    Tightening torque: 88.2 - 108 N·m

  19. Remove the transaxle mounting bracket (A).

    Tightening torque: 49.0 ~ 64 N·m

  20. To install, perform the removal procedure in reverse order.
Crossmember clamp, transaxle mounting bracket

Test yourself

A quick Hyundai i20 quiz: every answer comes with an explanation and a link to the manual page.