Hyundai i20 Quiz
Body Work (Interior and Exterior)

Center Pillar Trim Repair Procedures

In this manual: Body Work (Interior and Exterior)
General Information — 17Engine Mechanical System — 79Engine Electrical System — 50Emission Control System — 22Engine/Fuel Control System — 107Clutch System — 27MANUAL TRANSMISSION SYSTEM — 21Drive Shaft and Axle — 18Suspension System — 29Steering System — 21Restraint — 41Braking System — 53Body Work (Interior and Exterior) — 190Body Electrical System — 181Heating, Ventilation and Air Conditioning — 58
10steps
~60min
3/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 10

REPLACEMENT

[Center Pillar Lower Garnish]
  1. Remove the front door scuff plate. (Refer to Interior Trim - "Door Trim")
  2. Remove the rear door scuff plate. (Refer to Interior Trim - "Rear Door Scuff Plate")
  3. Carefully remove the weatherstrip from the front door.
  4. Carefully remove the weatherstrip from the rear door.
  5. Using a screwdriver or removal tool, remove the center pillar lower garnish (A).
  6. To install, perform the removal procedure in reverse order.
[Center Pillar Upper Trim]
  1. Remove the lower center pillar trim. (Refer to Interior Trim - "Center Pillar Trim")
  2. Loosen the mounting bolt, then remove the lower front seat belt anchor (A).

    Tightening torque: 39.2 ~ 54 N·m

  3. Using a screwdriver or removal tool, remove the center pillar upper garnish (A).
  4. To install, perform the removal procedure in reverse order.

Test yourself

A quick Hyundai i20 quiz: every answer comes with an explanation and a link to the manual page.