Rear Door Glass Repair Procedures

REPLACEMENT

1. 1
   Lower the rear door glass by pressing the power window switch.
2. 2
   Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")
3. 3
   Remove the rear door seat belt inner seal (B).

   

4. 4
   Using a screwdriver or puller, remove the rear door seat belt outer rubber seal (A).

   

5. 5
   Disconnect the rear door speaker connector (A).

   

6. 6
   After loosening the fixing screws, remove the fixing bracket of the rear door trim seal (A).
7. 7
   Remove the rear door trim seal (B).

   

8. 8
   Remove the rear door side seal.
9. 9
   After loosening the mounting bolt and screw, remove the lower rear delta channel (A).

   

10. 10
    Carefully adjust the rear door glass (A) until the bolts are visible, then loosen them. Separate the glass from the window regulator channel and carefully pull the window out through the window opening.

    Tightening torque: 3.9 ~ 5.9 N·m

    

11. 11
    To install, perform the removal procedure in reverse order.