Hyundai Kona Quiz
Heating, Ventilation, and Air Conditioning

Blower Resistor (Manual) Repair Procedures

In this manual: Heating, Ventilation, and Air Conditioning
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
5steps
~30min
2/5difficulty
Done 0 of 5

Inspection

  1. Measure the resistance between the terminals.
  2. If the measured resistance is not within specification, replace the blower resistor. (After removing the resistor)

Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Disconnect the connector (A) and remove the blower resistor (B) after loosening the mounting screws.
  3. Installation is the reverse of removal.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.