Hyundai Kona Quiz
Engine Electrical System

Cruise Control Switch Repair Procedures

In this manual: Engine Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
10steps
~60min
3/5difficulty
Done 0 of 10

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the steering wheel assembly. (Refer to Steering System – Steering Wheel)
  3. Remove the screws from the steering wheel rear cover (A).
  4. Disconnect the remote control connector on the steering wheel (A).
  5. After loosening the screws, remove the steering remote control switch (A).

Installation

  1. After connecting the connector, install the remote control switch on the steering wheel and install the cover.
  2. Install the steering wheel and the driver airbag module.
  3. Connect the negative (-) battery terminal.

Inspection

  1. Disconnect the cruise control switch connector from the control switch.
  2. Measure the resistance between the terminals of the control switch when each function switch is ON (switch pressed).
    Switch Connector Terminal Resistance
    (± 5%)
    CANCEL 2 - 6 390 Ω
    SET - 2 - 6 220 Ω
    VOICE + 2 - 6 300 Ω
    CRUISE 2 - 6 470 Ω

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.