Engine Electrical System
Specifications
In this manual: Engine Electrical System
~5min read
Specification
Ignition SystemIgnition Coil
| Item | Specification |
| Primary Winding Resistance (Ω) | 0,56 ± 15% [20 °C] |
Spark Plug
| Item | Specification |
| Type | SILZKR8E8G |
| Gap | 0.7 - 0.8 mm (0.0275–0.0314 in.) |
Charging System
Generator
| Item | Specification | |
| Rated Output | 13.5 V, 130 A | |
| Operating Speed | 1000–18,000 rpm | |
| Voltage Regulator | Built-in IC regulator type | |
| Regulator Set Voltage | External Mode | Refer to the graph below |
| Internal Mode | 14.55 ± 0.3 V | |
| Temperature Gradient | External Mode | 0 ± 3 mV/°C |
| Internal Mode | -3.5 ± 2 mV/°C | |
| Target Voltage Data (COM) | Frequency (Hz) | 115 - 500 |
| Signal Type | PWM | |
| Voltage Level (V) | High: 3.5 ± 0.2 | |
| Low: 1.5 ± 0.2 | ||
| Electrical Load (FR) | Frequency (Hz) | 250 ± 38 |
| Signal Type | PWM | |
| Vehicle Current Limit (mA) | 2,7–7,0 | |
| Pulley Type | AAD | |


Battery
▷AGM60L - DIN| Item | Specification |
| Capacity [20 hr / 5 hr] (Ah) | 60/48 |
| Cold Cranking Amps (A) |
640 (SAE/EN) |
| Reserve Capacity (min.) | 100 |
| Specific Gravity | 1300–1320 [25 °C] |
| Voltage (V) | 12 |
▷AGM70L - DIN
| Item | Specification |
| Capacity [20 hr / 5 hr] (Ah) | 70/56 |
| Cold Cranking Amps (A) |
760 (SAE/EN) |
| Reserve Capacity (min.) | 120 |
| Specific Gravity | 1300–1320 [25 °C] |
| Voltage (V) | 12 |
Starting System
Starter Motor
[Non-ISG]| Item | Specification | |
| Rated Voltage | 12 V, 0.9 kW | |
| Number of Gear Teeth | 10 | |
| Performance | Amperes | Max. 60 A |
| [No load, 11.5 V] | Speed | Min. 5500 rpm |
[ISG]
| Item | Specification | |
| Rated Voltage | 12 V, 1.3 kW | |
| Number of Gear Teeth | 11 | |
| Performance | Amperes | Max. 95 A |
| [No load, 11.5 V] | Speed | Min. 3400 rpm |
Tightening torque
| Item | N·m | kgf·m | lb-ft |
| Ignition coil mounting bolt | 9,8 - 11,8 | 1,0 - 1,2 | 7,2 - 8,7 |
| Spark Plug | 14,7 - 24,5 | 1,5 - 2,5 | 10,9 - 18,1 |
| Generator B terminal lock nut | 9,8 - 11,8 | 1,0 - 1,2 | 7,2 - 8,7 |
| Generator mounting bolt | 49,0 - 63,7 | 5,0 - 6,5 | 36,2 - 47,0 |
| Battery (+) Terminal Clamp Tightening | 7,8 - 9,8 | 0,8 - 1,0 | 5,2 - 8,7 |
| Battery (-) Terminal Clamp Nut Tightening | 3,9 - 5,9 | 0,4 - 0,6 | 2,9 - 4,3 |
| Battery mounting bracket bolt and nut | 18,7 - 29,4 | 1,9 - 3,0 | 13,7 - 21,8 |
| Battery Tray Mounting Bolt | 8,8 - 29,4 | 0,9 - 3,0 | 6,5 - 21,8 |
| Battery sensor cable mounting bolt (chassis ground) | 10,8 - 13,7 | 1,1 - 1,4 | 8,0 - 10,1 |
| Starter motor bolt | 49,0 - 63,7 | 5,0 - 6,5 | 36,2 - 47,0 |
Test yourself
A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?