Hyundai Kona Quiz
Body (Interior and Exterior)

Floor Console Assembly Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
22steps
~132min
5/5difficulty
Done 0 of 22

Replacement

[Manual Console]
  1. Remove the shift lever knob and boot (A) by turning the knob counterclockwise.
  2. Using a screwdriver or remover, remove the console upper cover (A).
  3. Disconnect the connector (A).
  4. Using a removal tool, remove the console upper front facia (A).
  5. After loosening the mounting screws, remove the floor console tray assembly (A).
  6. Disconnect the connector (A).
  7. Using a screwdriver or remover, remove the parking brake cover (A).
  8. Remove the storage box garnish (A).
  9. After loosening the mounting screws and bolts, remove the rear console complete assembly (A).
  10. After loosening the mounting clips, remove the floor console side cover (A).
  11. To install, reverse the removal procedure.
[Automatic Console]
  1. To remove the shift lever knob and boot (A), pull them upward.
  2. Using a screwdriver or removal tool, remove the floor console upper cover (A).
  3. Disconnect the connectors (A) from the floor console upper cover.
  4. Using a removal tool, remove the console upper front facia (A).
  5. After loosening the mounting screws, remove the floor console tray assembly (A).
  6. Disconnect the connector (A).
  7. Using a screwdriver or remover, remove the parking brake cover (A).
  8. Remove the storage box garnish (A).
  9. After loosening the mounting screws and bolts, remove the floor console assembly (A).
  10. After loosening the mounting clips, remove the floor console side cover (A).
  11. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.