Hyundai Kona Quiz
Body (Interior and Exterior)

Front Pillar Trim Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
2steps
~12min
2/5difficulty
Done 0 of 2

Replacement

  1. Remove the front pillar trim.
    1. To remove the front pillar garnish, use the clip remover (A) shown below.
    2. Slightly lift the front pillar garnish, insert the tool, and remove the mounting clip (A) by pulling it.
    3. Remove the front pillar trim (A).
  2. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.