Hyundai Kona Quiz
Body (Interior and Exterior)

Center Pillar Trim Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
10steps
~60min
3/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 10

Replacement

[Center Pillar Lower Trim]
  1. Carefully remove the front door side weatherstrip.
  2. Carefully remove the rear door body side weatherstrip.
  3. Remove the front door sill trim. (Refer to Interior Trim - "Door Scuff Trim")
  4. Remove the rear door sill trim. (Refer to Interior Trim - "Door Scuff Trim")
  5. Using a screwdriver or trim remover, remove the lower center pillar garnish (A).
  6. To install, reverse the removal procedure.
[Center Pillar Upper Trim]
  1. Remove the lower center pillar trim. (Refer to Interior Trim - "Center Pillar Trim")
  2. Loosen the mounting bolt and remove the front lower seat belt anchor (A).

    Torque: 39.2 – 54 N·m

  3. Loosen the mounting bolt and remove the upper center pillar garnish (A).
  4. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.