Hyundai Kona Quiz
Engine Mechanical System

Oil Cooler Repair Procedures

In this manual: Engine Mechanical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
8steps
~53min
3/5difficulty
1special tools
02040608010055.841N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Removal

  1. Loosen the drain plug and drain the coolant. Open the radiator cap to speed up draining. (Refer to Cooling System - Coolant)
  2. Disconnect the oil cooler hoses (A).
  3. Remove the oil filter (A) using SST (09263-2E000, oil filter wrench).
  4. Loosen the mounting bolt (A) and remove the oil cooler assembly (B).

    Tightening torque: 50.0–56 N·m

Installation

  1. Apply a thin layer of engine oil to the sealing surface of the oil cooler (A), then install the oil cooler (C) using the mounting bolt (B).

    Tightening torque: 50.0–56 N·m

  2. Install the oil filter (A) using SST (09263-2E000, oil filter wrench).

    Tightening torque: 11.7–15.6 N·m

  3. Install the oil cooler hoses (A).
  4. Fill the radiator with engine coolant and check for leaks. (Refer to Cooling System - "Engine Coolant")

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.