Hyundai Kona Quiz
Body Electrical System

Parking Distance Warning Sensor Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
7steps
~42min
2/5difficulty
Done 0 of 7

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover")
  3. Disconnect the connector (B) from the parking sensor (A).
  4. Remove the sensor (A) by pulling both ends of the sensor holder (B).

Installation

  1. Install the rear ultrasonic sensor after connecting the connector.
  2. Install the bumper cover.
  3. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.