Hyundai Kona Quiz
Steering

Repair Procedures

In this manual: Steering
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
16steps
~96min
4/5difficulty
0204060801004936N·mlb·ft
Tightening torque found on this page
Done 0 of 16

Removal

  1. Turn the ignition OFF and disconnect the negative (-) battery cable.
  2. Turn the steering wheel so that the front wheels point straight ahead.
  3. Remove the driver airbag (DAB) module. (Refer to Restraint – "Driver Airbag Module")
  4. Disconnect the steering wheel connector (A).
  5. Loosen the steering wheel lock bolt (B) and separate the steering wheel from the steering column.

    Tightening Torque: 44.1–49 N·m

Installation

  1. Install in the reverse order of removal.

Disassembly

[Non-Paddle Shift Type]
  1. Loosen the screw and remove the lower cover (A).
  2. Disconnect the remote control switch connector (A).
  3. Disconnect the steering wheel heating wire (B) from the steering wheel after loosening the screw (A).
  4. Loosen the screw (A) and remove the remote control switch (B).
  5. Remove the steering wheel ornament (A).
  6. Remove the clock spring (A) and disconnect the connector.
  7. Loosen the screw and remove the lower cover.
  8. Disconnect the remote control switch connector (A).
  9. Disconnect the steering wheel heating wire (B) from the steering wheel after loosening the screw (A).
  10. Loosen the screw (A) and remove the remote control switch (B).
  11. Remove the steering wheel ornament (A).
[Paddle Shift Type]

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.