Hyundai Kona Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
10steps
~60min
3/5difficulty
Done 0 of 10

Inspection

Check this by performing the procedure below to confirm that the ECM operates normally.
  1. Turn the ignition switch to the "ON" position.
  2. Cover the front sensor.
  3. Direct light at the rear view sensor.
  4. The ECM should dim as soon as the rear sensor detects the light.
  5. When reverse gear is engaged, the ECM must not dim. When light is directed at both the front and rear sensors, the ECM must not dim.

Removal

  1. Remove the mirror wiring cover (A).
  2. Disconnect the mirror connector (A).
  3. Remove the mirror (A) by pulling up in the direction of the arrow.

Installation

  1. Install the mirror, making sure the mounting bracket is not damaged.
  2. After reconnecting the connector, install the mirror wiring cover and rain sensor cover and tighten the screw.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.