DCT (Dual Clutch Transmission) System
Special Service Tools
In this manual: DCT (Dual Clutch Transmission) System
~1min read
10special tools
Special Service Tools
| Tool (Number and Name) |
Illustration | Use |
| 09200-3N000 Engine Support Bracket (Beam) |
 |
Transmission Removal and Installation. Use this beam (SST No.: 09200-3N000) with support (SST No.: 09200-2S000). ※ Work permitted with 09200-38001. ※ Refer to the engine mount bracket assembly illustration below. |
| 09200-2C000 Engine Support Bracket (Support) |
 |
Transmission Removal and Installation. Use this beam (SST No.: 09200-38001/3N000) with support (SST No.: 09200-2S000). ※ Refer to the engine mount bracket assembly illustration below. |
| 09430-C1190 Seal Installer |
 |
Used to install the differential oil seals on both sides for 2WD vehicles. [Use with handle (SST No. 09231-H1100)] [2WD] |
| 09431-39000 Seal Installer |
 |
Used to install the differential seal. [Use with handle (09500-11000)] [4WD] |
| 09473-D3500 Seal Installer |
 |
Used to install the driven gear seal. Use with handle (09231-H1100) [4WD] |
| 09231-H1100 Bar |
 |
Use with seal installer. |
| 09500-11000 Bar |
|
Use with seal installer. |
| 09480-A3800 Inhibitor Switch Neutral Fixing Pin |
 |
When installing the control lever to the lock switch, align the neutral position. |
| 09430-C1180 Dual Clutch Remover |
 |
Used to remove the dual clutch assembly. |
| 09430-2A240 Dual Clutch Installer |
 |
Used to install the dual clutch assembly. |
| 09430-C1300 Clutch Wear Compensation Tool |
 |
Used to adjust the clutch actuator. |
| 09430-C1302 Actuator Fixing Jig and Engine Shaft Reset Tool |
 |
Used to adjust the clutch actuator. Use with clutch actuator adjuster |
| 09430-A5100 Clutch Release Fork Fixing Tool |
 |
Used to remove the clutch actuator assembly. |
Test yourself
A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?