Hyundai Kona Quiz
Four-Wheel Drive (4WD) System

Transfer Fluid Repair Procedures

In this manual: Four-Wheel Drive (4WD) System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
12steps
~72min
3/5difficulty
02040608010058.843N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Inspection

  1. Remove the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")
  2. Remove the fill plug (A).
  3. Check the oil level.
  4. The oil level should be at the bottom edge of the filler hole. If not, add oil until it starts to flow out.
  5. Install the filler plug (A) with a new gasket.

    Torque: 39.2 – 59 N·m

  6. Install the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")

Replacement

  1. Remove the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")
  2. Drain the transaxle oil after loosening the drain plug (A).
  3. Install the drain plug with a new gasket.

    Torque: 39.2 – 59 N·m

  4. Remove the filler plug (A). Standard Oil: API GL-5 Hypoid Gear Oil, SAE 75W/90 (SHELL HD AXLE OIL 75W/90 or equivalent). Oil Capacity: The oil level should be at the bottom edge of the filler hole. If not, add oil until it starts to flow out.
  5. Install the filler plug with a new gasket.

    Torque: 39.2 – 59 N·m

  6. Install the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.