Hyundai Tucson Quiz
Body Electrical System

REAR WIPER MOTOR Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
18steps
~108min
4/5difficulty
010203040509.87N·mlb·ft
Tightening torque found on this page
Done 0 of 18

Inspection

REAR WIPER MOTOR
  1. Disconnect the rear wiper motor connector.
  2. Connect the positive (+) battery cable to terminal 4 and the negative (-) battery cable to terminal 3.
  3. Check that the motor operates correctly. If the windshield washer motor operates abnormally, replace it.
    No. Description
    1 Battery (+)
    2 PARK
    3 MASS
    4 Rear wiper motor (+)

  4. Using the accelerator, run the engine at low speed.
  5. Stop the motor at any position other than OFF, then disconnect the motor connector.
  6. Connect the positive (+) battery cable to terminal 1 and the battery. Connect the negative (-) to terminal 3.
  7. Connect motor terminal 2 and terminal 4.
  8. Check that the motor stops in the OFF position.
Automatic Stop Operation Check

Verification (with GDS)

  1. In the body electrical system, a fault can be quickly diagnosed using the Global Diagnostic System (GDS). The GDS provides the following information.
    1. Self-diagnosis: checks for malfunctions and the number of codes (DTC)
    2. Current data: checking the input/output status of the system
    3. Operation check: checks the operating conditions of the system
    4. Additional function: controls other functions, including additional system setup and zero point adjustment
  2. Select "Vehicle Model" and "Body Control Module (BCM)" to check the vehicle with the tester.
  3. Select the "Current Data" menu to check the current status of inputs and outputs.

DEPOSIT

  1. Remove the rear wiper blade and arm (B) after removing the nut, and loosen the cap (A).
  2. Remove the rear door trim after opening the rear door. (Refer to Body - "Rear Door Trim")
  3. Disconnect the rear wiper motor connector (A), then remove the rear wiper motor (B) after loosening the bolts (3 pcs).

REMEDY

  1. Install the rear wiper motor assembly.

    Nut tightening torque: 6.9~9.8 N·m

  2. Install the rear door trim panel.
  3. Install the rear wiper arm and rear wiper arm cap.

    Nut tightening torque: 8.8~10.8 N·m

  4. Install the rear wiper blade on the heater lower defroster line and on the tailgate glass.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.