Hyundai Tucson Service and Repair Procedures

ITEM

Check Glass Alignment

1
Check the alignment of the sliding glass (C) located between the front glass (A) and the rear glass (B), and adjust if necessary. Alignment Adjustment Specification [mm (in)] (1) Front edge: 0 mm (0 in) (2) Rear edge: 0 mm (0 in)
2
Adjust the glass height by slightly loosening the screws.
NOTE
- Be careful not to damage the screws.
3
Use the sunroof emergency mode only when the sunroof cannot be opened or closed due to an engine problem.
4
Use a hex wrench to open or close the sunroof after the headliner has been removed. When opening or closing the sunroof, do not apply excessive force. [Sunroof Motor]
[Sunshade Motor]
5
If necessary, initialize the sunroof according to the initialization method.
NOTE※ Sunroof Reset: When the one-touch function is activated with the switch, but the glass or sunshade does not move automatically and only moves when the switch is held manually, the default setting has been erased. In this case, the sunroof must be reset as described below.
NOTEThe sunroof motor must be reset to its default settings in the following cases:
- The sunroof motor may temporarily stop working after replacing the battery or fuse, or if the battery has discharged.
- The automatic open or close one-touch function does not operate correctly.
- The sunroof reopens automatically while closing even if no object is caught in it (safety function).
1. After ALL ON, use the CLOSE switch to fully close the sunroof and sunshade.
2. When the glass and sunshade are fully closed, release the CLOSE switch, then turn and hold the switch (about 10 seconds) until the glass and shade move slightly once.
3. Release the CLOSE switch, then press and hold the switch again. The glass and sunshade open and close in the order below and the sunroof reset process is complete. Sliding sunshade open → Tilt glass open, then slide close → Sliding and shade close.
※ If the CLOSE switch is released during the above operation, the reset process is cancelled and you must return to step 1 and restart the process.

Emergency Operation

Repair Procedures

ITEM

Test yourself