Hyundai Tucson LM Quiz
Clutch System

Clutch Master Cylinder Repair Procedures

In this manual: Clutch System
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
3steps
~18min
2/5difficulty
Done 0 of 3

Removal
Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.
  1. Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer (B).
  2. Disconnect the clutch tube (B) and the reservoir hose (A) from the clutch master cylinder.
  3. Remove the clutch master cylinder by turning it clockwise (A).

Installation

  1. Installation is the reverse of removal.
    • After refilling with brake fluid, perform the air bleeding procedure for the clutch release cylinder. (Refer to "Clutch Release Cylinder" in Group CH.)

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.