Repair Procedures of Passenger Airbag (PAB) Module

Removal

1. 1
   Disconnect the negative battery cable and wait at least three minutes before starting work.
2. 2
   Remove the glove box housing. (Refer to Body - Airbag group).
3. 3
   Disconnect the passenger airbag connector and remove the PAB mounting bolt.

   

4. 4
   Remove the emergency airbag. (Refer to Body - Airbag group).

   Replace the emergency airbag if it was damaged during PAB deployment.

5. 5
   Remove the heater duct from the airbag.
6. 6
   Remove the airbag mounting nuts (4 pcs). Then remove the passenger airbag.

   Store the removed airbag module in a clean, dry place with the airbag facing up.

Installation

1. 1
   Remove the ignition key from the vehicle.
2. 2
   Disconnect the negative battery cable from the battery and wait at least three minutes before starting work.
3. 3
   Place the passenger airbag on a protective cover and tighten the passenger airbag mounting bolts.

   Tightening torque: 5.9 ~ 6.9 N·m

   

4. 4
   Install the heater duct on the emergency airbag.
5. 5
   Install the emergency airbag. (Refer to Body - Airbag group)
6. 6
   Tighten the passenger airbag mounting bolt.

   Tightening Torque: 18.6 ~ 26 N·m

7. 7
   Connect the passenger airbag wiring harness connector to the SRS main wiring harness connector.
8. 8
   Reinstall the glove box. (Refer to Body - Airbag group)
9. 9
   Connect the negative battery cable.
10. 10
    After installing the passenger airbag (PAB), check that the system operates correctly:

    A.	Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.