Hyundai Tucson LM Quiz
Body Electrical System

Power Door Lock Actuator Repair Procedures

In this manual: Body Electrical System
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
22steps
~132min
4/5difficulty
Done 0 of 22

Inspection

Front Door Lock Actuator
  1. Remove the front door trim panel. (Refer to BD group - "Front Door")
  2. Remove the front door module. (Refer to BD group - "Front Door")
  3. Disconnect the actuator connectors.
  4. Check actuator operation by connecting power and ground as specified in the table. To prevent damage to the actuator, apply battery voltage only momentarily. [Central Door Lock]
    [Dead Lock]
  5. Remove the rear door trim panel. (Refer to BD group - "Rear Door")
  6. Remove the rear door module. (Refer to BD group - "Rear Door")
  7. Disconnect the actuator connectors.
  8. Check actuator operation by connecting power and ground as specified in the table. To prevent damage to the actuator, apply battery voltage only momentarily. [Central Door Lock]
    [Dead Lock]
  9. Remove the rear door trim panel. (Refer to BD group - "Rear Door")
  10. Disconnect the 4P connector from the actuator.
  11. Check actuator operation by connecting power and ground as specified in the table. To prevent actuator damage, apply battery voltage only momentarily.
  12. Remove the front door trim panel. (Refer to BD group - "Front Door")
  13. Remove the front door module. (Refer to BD group - "Front Door")
  14. Disconnect the actuator connectors.
  15. Check continuity between terminals at each switch position when the key is inserted in the door, as specified in the table. [Central Door Lock]
    [Dead Lock]
  16. Remove the rear door trim panel. (Refer to BD group - "Rear Door")
  17. Remove the rear door module. (Refer to BD group - "Rear Door")
  18. Disconnect the actuator connectors.
  19. Check continuity between terminals at each switch position as specified in the table. [Central Door Lock]
  20. Remove the rear door trim panel. (Refer to BD group - "Rear Door")
  21. Disconnect the 4P connector from the actuator.
  22. Check the continuity between the terminals at each switch position according to the table.
Rear Door Lock Actuator Rear Liftgate Lock Actuator Inspection Front Door Lock Switch Rear Door Lock Switch Rear Door Switch

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.