Hyundai Tucson LM Quiz
Body (Interior and Exterior)

Rear Seat Belt Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
18steps
~108min
4/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 18

Replacement

Additional Seat Belt Replacement
  • When installing the seat belt, take care not to damage the pretensioner.
  1. Remove the rear seat. (Refer to Seat and Power Seat - "Rear Seat")
  2. Remove the rear door sill trim. (Refer to Interior - "Interior Trim")
  3. Loosen the mounting bolt, then remove the lower anchor of the rear seat belt (A).

    Tightening torque: 39.2 ~ 54 N·m

  4. Remove the clips.
  5. Using a screwdriver or remover, remove the side cover (A).
    • Using a flat-tip screwdriver, wrap protective tape around the tip and apply protective tape around the relevant parts to prevent damage.
  6. Loosen the mounting bolts, then remove the rear seat bracket (A).
  7. Disconnect the lamp (A).
  8. Disconnect the connector (B).
  9. Loosen the mounting screws, then remove the side luggage trim (C).
  10. Loosen the mounting bolt and screws, then remove the rear pillar trim (A).
  11. Loosen the mounting bolts, then remove the rear seat belt (A).

    Tightening torque: 39.2 ~ 54 N·m

  12. Install in the reverse order of removal.
    • Replace any damaged clips.
Rear Center Seat Belt Retractor
  • When installing the seat belt, take care not to damage the pretensioner.
  1. Remove the headliner assembly. (Refer to Headliner - "Headliner Assembly")
  2. Loosen the mounting bolts, then remove the second row center seat belt pretensioner (A).

    Tightening torque: 39.2 ~ 54 N·m

  3. Install in the reverse order of removal.
    • Replace all damaged clips.
  4. Remove the rear seat. (Refer to Seat and Power Seat - "Rear Seat")
  5. Loosen the mounting bolt, then remove the seat belt buckle (A).

    Tightening torque: 39.2 ~ 54 N·m

    Tightening torque: 39.2 ~ 54 N·m

  6. Install in the reverse order of removal.
Rear Seat Belt Buckle Replacement

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.