Hyundai Tucson LM Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
14steps
~84min
3/5difficulty
Done 0 of 14

Inspection

  1. Disconnect the ignition switch connector (B) and the key warning switch connector (A) from under the steering column.
  2. Check the circuit between the terminals for continuity.
  3. If continuity is not as specified, replace the switch.

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the upper and lower steering column covers. (Refer to Group ST - "Steering Column")
  3. Remove the ignition lock (A) after disconnecting the 6-pin connector (B).
  4. Remove the key warning switch and immobilizer connector (A).
  5. Remove the key illumination lens (A).
  6. If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder by pressing the stopper pin (B) with the key in the ACC position.

Installation

  1. Install the key cylinder lock.
  2. Install the illumination lamp, lens and cover.
  3. Install the key warning switch and the immobilizer connector.
  4. Install the ignition lock.
  5. Install the steering column covers and the lower airbag panel.

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.