Body Electrical System

Speaker Repair Procedures

18steps
~108min
4/5difficulty
Done 0 of 18

Inspection

  1. Speaker Troubleshooting
    1. Basic speaker inspection: Check the sound from the speaker, making sure the speaker mounting screws are removed and the wiring connector is connected, to eliminate any possible vibration transmitted from the body trim and surrounding parts.
    2. Troubleshooting
      No. Symptom Inspection/Remedy
      1 Rattling Noise
      1. Before replacing the speaker, make sure the mounting screw is installed properly.
      2. After reinstalling the speaker, make sure there is no rattling noise.
      3. If the rattling noise occurs again, replace the speaker with a new one.
      2 Noise
      1. Check whether the wiring connector is connected properly. If not, connect the wiring connector.
      2. In case of radio interference, check for noise from the CD player.
      3. If noise is heard when the radio and CD are turned on, replace the speaker with a new one.
      If only radio interference occurs, it is caused by poor radio reception. Therefore, the speaker does not need to be repaired or replaced.
      3 Poor Performance Check the wiring connection between the battery and the speaker
      1. Before replacing the speaker, check the wiring connection between the battery and the speaker.
      2. Check the speaker power supply and resistance, then check the sound quality.
      3. If the speaker performs poorly, replace it with a new one.

      When handling speakers:
      • Do not damage the speaker by impact, such as dropping or throwing it.
      • Be careful not to spill water or oil on the speakers.
      • Be careful when handling the speaker, because the diaphragm material is paper, which tears easily under impact or external force.
      • Modifying the audio system may damage the speakers. Speakers modified in this way are not covered by the manufacturer's warranty.

Removal

Front Speaker
  1. Remove the front door trim panel. (Refer to BD group - "Front Door")
  2. Remove the front speaker (A) by removing the 4 screws.
  3. Remove the rear door trim panel. (Refer to BD group - "Rear Door")
  4. Remove the rear speaker (A) after removing the 4 rivets.
  5. Remove the front door delta cover (A).
    Be careful not to damage or scratch the delta cover and related parts.
  6. Remove the tweeter speaker by disconnecting the connector (A).
  7. Remove the right side trim panel of the luggage compartment. (Refer to BD group - "Interior Trim")
  8. Disconnect the woofer speaker connector (A).
  9. Remove the woofer speaker (A) by removing the screws (2 pcs.) and nuts (2 pcs.).
Rear speaker Front tweeter speaker Woofer speaker

Installation

Front Speaker
  1. Install the speaker into the speaker mounting hole in the door panel.
  2. Reconnect the speaker connector.
  3. Install the speaker into the speaker mounting hole in the door panel.
  4. Reconnect the speaker connector.
  5. Install the front tweeter speaker on the front door delta cover.
  6. Connect the connector, then install the delta cover.
  7. Install the woofer speaker on the inner panel of the left quarter panel.
  8. Connect the connector
  9. Install the right trunk side trim.
Rear speaker Front tweeter speaker Woofer speaker

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.