Jeep Wrangler: Wrangler Instrument Cluster / Instrument Cluster Description

1
Tachometer
- Indicates engine speed in revolutions per minute (rpm x 1000).
Caution
!
Do not operate the engine with the tachometer needle in the red zone. Engine damage may occur.
2
Temperature Gauge
- The coolant temperature gauge shows the engine coolant temperature. Any reading within the normal range indicates that the engine cooling system is operating satisfactorily.
- The gauge will most likely show a higher temperature when driving in hot weather, on steep grades, or when towing a trailer. Never allow the temperature to exceed the upper limit of the normal operating range.
Warning
!
The engine cooling system is hot and can cause serious burns. You or others may be seriously burned by steam or boiling coolant. Contact an authorized dealer for service if your vehicle overheats.

Caution
!
Driving with a hot engine cooling system may damage your vehicle. If the temperature gauge shows "H", pull over and stop the vehicle. Idle the vehicle with the air conditioner off until the needle returns to the normal range. If the gauge remains on "H", turn off the engine immediately and contact an authorized dealer for service.
3
Instrument Cluster Display
- The instrument cluster display includes an interactive driver information display.
Instrument Cluster Display Location
4
Fuel Gauge
- The needle shows the fuel level in the fuel tank when the ignition is in the ON/RUN position.
- The fuel pump symbol points to the side of the vehicle where the fuel filler door is located.
5
Speedometer
- Indicates vehicle speed.

Instrument Cluster Description

Test yourself