Battery Charging

• Remove the battery from the motorcycle (see Battery Removal).
• Attach the leads from the charger and charge the battery at a rate (amperage x hours) that is indicated on the battery. If it is not possible to read the rate, charge the battery at an amperage that is about 1/10th of the battery capacity.
• The charger will keep the battery fully charged until you are ready to reinstall the battery in the motorcycle (see Battery Installation).

NOTICE

Never remove the sealing strip, or the battery can be damaged.

Do not install a conventional battery in this motorcycle, or the electrical system cannot work properly.

NOTE

If you charge the sealed battery, never fail to observe the instructions shown in the label on the battery.

Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling.