Electrical Wiring

Wiring Inspection

• Visually inspect the wiring for signs of burning, fraying, etc.

If any wiring is poor, replace the damaged wiring.

• Pull each connector [A] apart and inspect it for corrosion, dirt, and damage.

If the connector is corroded or dirty, clean it carefully. If it is damaged, replace it.

• Check the wiring for continuity.

Use the wiring diagram to find the ends of the lead which is suspected of being a problem.

Connect the hand tester between the ends of the leads.

Special Tool - Hand Tester: 57001-1394

Set the tester to the × 1 Ω range, and read the tester.

If the tester does not read 0 Ω, the lead is defective. Replace the lead or the wiring harness [A] if necessary.