Flap and Rear Fender Rear Installation

• Installation is the reverse of removal. Note the following.

Fit the tab [A] to the slot [B].

Run the seat lock cable [C] between the tool kit case and the turn signal light as shown in the figure.

When installing the dampers [A] on the lower pipe [B], install it as shown in the figure.

Front End [C] Viewed from Upper Side [D] Viewed from Left Side [E]

• Turn the notch [A] of the lower pipe [B] toward up.
• Insert the license plate light lead in the lower pipe.
• For US, CA and CAL models, insert the licence plate light lead and the rear turn signal light leads in the lower pipe.

Insert the tabs [A] into the upper pipes [B].

Install the bracket [A] on the upper pipes as shown in the figure.