Rear Fender Front Installation

• Installation is the reverse of removal. Note the following.

Run the harness, cables and leads correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter).

• When installing the clamp [A] on the rear fender front [B], install it so that the clamp positions at near the corner end [C] as shown in the figure.

• When installing the pads [A] and damper [B], first install the pad and then install the damper as follows.
• Install the pads along the lines [C] of the fender as shown in the figure.
• Install the damper so that the start position [D] is point in the figure.

Viewed from Upper Side [E] Viewed from H-H [F] Viewed from I-I [G] Front Side [J] ZX1000J Model [K] ZX1000K Model [L]