Front Seat Belt Repair Procedures

Replacement

When installing the seat belt, take care not to damage the pretensioner.

1. 1
   First remove the following items:

   • Front Seat Assembly (Refer to Group BD - "Front Seat")
   • Front and Rear Door Scuff Plate (Refer to Group BD - "Interior Trim")
2. 2
   The pretensioner seat belt anchor (A) can be removed by pressing the locking pin (B) in the direction of the arrow.

   

3. 3
   Remove the center pillar lower garnish (A).

   

4. 4
   Loosen the mounting bolts, then remove the upper center pillar garnish (A).

   

5. 5
   Loosen the mounting bolt, then remove the upper anchor (A).

   Tightening torque: 39.2 ~ 54 N·m

   

6. 6
   After releasing the lock pin of the pretensioner connector, disconnect the SIS connector (A), loosen the mounting bolt, then remove the pretensioner (B).

   Tightening torque: 39.2 ~ 54 N·m

   

7. 7
   Installation is the reverse of removal.
8. 8
   First remove the following items:

   • Front Seat Assembly (Refer to Group BD - "Front Seat")
   • Front Door Scuff Plate and Rear Door Scuff Plates (Refer to Group BD - "Interior Trim")
   • Front Seat Belt Lower Anchor
   • Lower Center Pillar Garnish (Refer to Group BD - "Interior Trim")
   • Upper Center Pillar Garnish (Refer to Group BD - "Interior Trim")
   • Front Seat Belt Upper Anchor
9. 9
   Loosen the bolts, then remove the height adjuster (A).

   Tightening torque: 39.2 ~ 54 N·m

   

10. 10
    Installation is the reverse of removal.

    Replace any damaged clips. Make sure the height is adjusted correctly.

11. 11
    Remove the front seat assembly. (Refer to Group BD - "Front Seat")
12. 12
    Loosen the mounting bolt and remove the front seat belt buckle (A).

    Tightening torque: 39.2 ~ 54 N·m

    

13. 13
    Disconnect the connector mounting clip (A).

    

14. 14
    Installation is the reverse of removal.