Kia Cadenza VG Owner's Manual Quiz
Body Electrical System

Relay Box (Interior) Repair Procedures

In this manual: Body Electrical System
General Information — 15Engine Mechanical System — 95Engine Electrical System — 54Emission Control System — 24Engine Control System/Fuel System — 115Automatic Transmission — 91Drive Shaft and Axle — 13Suspension System — 35Steering — 19Restraints — 46Brake System — 43Body (Interior and Exterior) — 51Body Electrical System — 245Heating, Ventilation, and Air Conditioning — 56
11steps
~66min
3/5difficulty
Done 0 of 11

Fuse Inspection

  1. Make sure that there is no play in the fuse holders and that the fuses are securely installed.
  2. Is the rating of the fuse specified correctly for each circuit?
  3. Is there a blown fuse? If a fuse must be replaced, be sure to use a new fuse of the same capacity. Always determine why the fuse blew first and fully correct the problem before installing a new fuse.

Removal

IPM
  1. Disconnect the negative (-) battery terminal.
  2. Remove the lower driver airbag panel. (Refer to Body - "Driver Airbag Module")
  3. Disconnect the connectors (A) from the IPM (Intelligent Power Module).
  4. Remove the IPM by loosening the mounting nuts (2) and bolt (1).
  5. Disconnect the connectors from the rear of the IPM.

Installation

  1. Install the IPM (Intelligent Power Module).
  2. Connect the IPM connector.
  3. Install the emergency pad lower panel.

Test yourself

A quick Kia Cadenza VG Owner's Manual quiz: every answer comes with an explanation and a link to the manual page.