Suspension System

Alignment Repair procedures

8steps
~48min
3/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Front wheel alignment

Toe

B - A > 0: Toe in (+) B - A < 0: Toe out (-)

Toe adjustment

  1. Loosen the tie rod end lock nut.

  2. Remove the bellows clip to prevent the bellows from being twisted.

  3. Adjust the toe by screwing or unscrewing the tie rod. Toe adjustment should be made by turning the right and left tie rods by the same amount.

    Toe-in Total : 0.1° ± 0.2° Individual : 0.005° ± 0.1°

  4. When completing the toe adjustment, install the bellows clip and tighten the tie rod end lock nut to specified torque.

    Tightening torque: 49.0 - 54 N·m

  5. Perform the Steering Angle Sensor calibration.

    • MDPS : (Refer to Steering System - "Electric Power Steering")

Camber and Caster

Camber and Caster are pre-set at the factory, so they do not need to be adjusted. If the camber and caster are not within the standard value, replace or repair the damaged parts and then inspect again.

Camber angle : -0.4°±0.5°

Caster angle : 4.4°±0.5°

Rear wheel alignment

Toe

B - A > 0: Toe in (+) B - A < 0: Toe out (-)

Toe adjustment

  1. Loosen the nut holding the assist arm cam bolt (A).

  2. Adjust rear toe by turning the rear assist arm cam bolt (A) clockwise or counter clockwise. Toe adjustment should be made by turning the right and left cam bolt by the same amount.

    Toe-in Total : 0.14°±0.2° Individual : 0.07°±0.1°

  3. When completing the toe adjustment, tighten the nut to specified torque.

    Tightening torque: 107.9 - 118 N·m

Camber

Camber is pre-set at the factory, so it does not need to be adjusted. If the camber is not within the standard value, replace or repair the damaged parts and then inspect again.

Camber : -1.2° ± 0.5°