Suspension System
Wheel Repair procedures
In this manual: Suspension System
3steps
~18min
2/5difficulty
Done 0 of 3
Hub nut tightening sequence
Tighten the hub nuts in the following sequence.
Tightening torque: 88.3 - 108 N·m

Run out inspection
Jack up the vehicle.
Measure the wheel run-out by using a dial indicator as shown below.
Run-out Aluminum Radial mm (in.) Below 0.3 (0.0118) Lateral mm (in.) Below 0.3 (0.0118) If measured value exceeds the standard value, replace the wheel.

Was this page helpful?