Audio Remote Control Repair procedures
Removal
Disconnect the negative (-) battery terminal.
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel")
Remove the steering back cover (A) after loosening the mounting screws.


Remove the wiring connector (A) from the steering back cover.

Disconnect the steering wheel remote control connector (A).
[LH]

[RH]

Remove the steering wheel remote control assembly (A) after loosening the mounting screws.


Remove the steering wheel remote control (A) after loosening the mounting screws.
[LH]

[RH]

Installation
Install the steering wheel remote control.
Install the steering wheel remote control assembly.
Connect the steering wheel remote control connector.
Install the steering back cover.
Install the steering wheel and driver airbag module.
Connect the negative (-) battery terminal.
Inspection
Check for resistance between terminals in each switch position (LH).

[LH : Audio + Hands free + Voice]
Switch Connector
terminalResistance
(±3%)SEEK Up 1-6 430 ? SEEK Down 1.11 k? MODE 2.11 k? MUTE 3.11 k? Volume (+) 4.61 k? Volume (-) 6.81 k? Voice 10.71 k? END 18.91 k? SEND 40.91 k? Check for resistance between terminals in each switch position (RH).

[RH : Cruise + Trip]
Switch Connector
terminalResistance
(±5%)Cancel 2-6 390 ? SET - 610 ? RES + 910 ? Cruise ON/OFF 1.38 k? Cruise & Speed Limit ON/OFF 2.13 k? SCC (Following distance control) 3.63 k? Group 1-6 390 ? Trip Up 610 ? Trip Down 910 ? ENTER 1.38 k?