Heating, Ventilation and Air Conditioning

Blower Motor Repair procedures

7steps
~42min
2/5difficulty
Done 0 of 7

Inspection

  1. Operate the heater controls at IGN2 to ensure that the motor is running.

    1. Battery (+)
    2. Input signal
    3. ?
    4. Ground
  2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.

  3. Replace the blower motor if it is proved that there is a problem with it.

Replacement

  1. Disconnect the negative (-) battery terminal.

  2. Remove the crash pad under cover (A) by pushing the locking pin.

  3. Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.

  4. Install in the reverse order of removal.