DCT(Dual Clutch Transmission) System

Clutch Engagement Fork and Engagement Bearing Repair procedures

11steps
~66min
3/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 11

Removal

  1. Remove the dual clutch assembly.

    (Refer to Dual Clutch System - "Dual Clutch Assembly")

  2. Remove the clutch engagement bearing 1 (A) and 2 (B).

  3. Remove the clutch engagement fork 1 (A).

  4. Remove the clutch engagement fork 2 (A) and engagement bearing sleeve (B).

Installation

  1. Apply the grease on end part of fork.

    Specified grease : Extreme pressure grease for vehicle Quantity : 0.1 - 0.2 g

  2. Install the clutch engagement fork 2 (A) and the bearing sleeve (B) together.

    Tightening torque : 9.8 - 11,8 N·m

  3. Install the engagement fork 1 (A).

    Tightening torque : 9.8 - 11,8 N·m

  4. Install the engagement bearing 1 (A).

  5. Install the engagement bearing 2 (A).

  6. Install the dual clutch assembly.

    (Refer to Dual Clutch System - "Dual Clutch Assembly")

  7. Perform the clutch touch pointlearning procedure using the KDS/GDS.