Maintenance

Engine Oil and Filter Repair procedures

13steps
~83min
4/5difficulty
1special tools
0102030405015.712N·mlb·ft
Tightening torque found on this page
Done 0 of 13

Inspection

Engine Oil Level

  1. Warm up and stop the engine, and then wait for 5 minutes.

  2. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan.

  3. Pull the dipstick out, wipe and re-insert it fully.

  4. Check that the oil level is between the "L" level mark and "F" level mark on the engine oil level gauge.

  5. If the level is low, check for leakage and add oil up to the full level mark.

Engine Oil Appearance

  1. Check engine oil for white turbidity or heavy contamination.

  2. If engine oil becomes turbid and white, it is highly probable that it is contaminated with engine coolant.

    Repair or replace damaged parts.

Replacement

  1. Park the car on level ground.

  2. Drain engine oil.

    1. Remove the oil filler cap (A).

    2. Remove the drain under cover (A).

    3. After lifting the car, remove the oil drain plug (A) and drain oil into a container.

  3. Replace the oil filter.

    1. Remove the oil filter cover (A).

    2. Using the SST (09263-2E000), remove the oil filter (A).

    3. Check and clean the oil filter installation surface.

    4. Check the part number of the new oil filter is as same as old one.

    5. Apply clean engine oil to the gasket of a new oil filter.

    6. Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.

    7. Tighten it with the torque below.

      Tightening torque : 11.8 - 15,7 N·m

    8. Install the oil filter cover (A).

  4. Refill with the engine oil.

    1. Install the oil drain plug with a new gasket (A).

      Tightening torque : 34.3 - 44 N·m

    2. Install the drain under cover (A).

    3. Fill with new engine oil while checking the oil level on the dipstick.

      Capacity

      Total :

      4.1 L (1.08 U.S.gal., 4.33 U.S.qt., 3.61 lmp.qt.)

      Oil pan :

      3.4 L (0.90 U.S.gal., 3.59 U.S.qt., 2.99 lmp.qt.)

      Drain and refill including oil filter :

      3.8 L (1.00 U.S.gal., 4.02 U.S.qt., 3.34 lmp.qt.)

    4. Install the oil filler cap (A) and the oil dipstick.

  5. Start the engine and check that no oil is leaking from the drain plug or oil filter.

  6. Recheck the engine oil level.