Maintenance
Spark Plug Repair procedures
In this manual: Maintenance
9steps
~54min
2/5difficulty
Done 0 of 9
Inspection
[On vehicle inspection]
Accelerate the engine to about 3,000 rpm 3 times or more.
Remove the spark plug.
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the electrode is wet, check the damage and electrode gap as below.
[Component Inspection]
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug.
Check the electrode. Measure the insulation resistance with an ohmmeter.
If the resistance is less than the specified value, adjust the electrode gap.
Specification: 10 MΩ or more

Check the spark plug electrode gap.
If the gap is greater than the maximum, replace the spark plug.
Specification: 0.7 - 0.8 mm (0.0276 - 0.0314 in.)

Replacement
Remove the ignition coil.
(Refer to Ignition System - "Ignition Coil")
Using a spark plug wrench, remove the spark plug (A).
spark plug : 19.6 - 24 N·m

Install in the reverse order of removal.
Was this page helpful?